Tutorials ✍️

• Geometry Modeling and Preparation for Automated Meshing: An Example of the ONERA M6 Wing
  • 3D Sketches of Airfoils
  • Wing Planform
  • Wing Solid Model
  • Adding Edge Attribute
  • Adding Face and Group Attributes
• Non-Dimensionalization and Integrated Loads Post-Processing in Flow360
  • Introduction
  • Flow360 json file input calculations
  • Force and Moments Output Conventions
• RANS CFD on 2D High-Lift System Configuration Using the Flow360 Python Client
  • Modeling Multi-element Configurations in ESP
  • RUN CFD on multi-element configurations using Flow360
• Blade Element Theory using the XV-15 rotor
  • Preprocessing
  • Flow360 BET Configuration
  • Output and postprocessing
• Time-accurate RANS CFD on a propeller using a sliding interface: the XV-15 rotor geometry
  • Rotational and stationary volumes
  • Sliding interface requirements
  • XV-15 setup
  • Defining a Mesh.json file
  • Uploading your mesh
  • Defining a case configuration file.
  • Case input conditions
  • Case running
• Calculating Dynamic Derivatives using Sliding Interfaces
  • Geometry and Mesh
  • Case Setup
  • Submission
  • Postprocessing
• Automated Meshing for Internal Flow
  • Geometry
  • Surface Mesh
  • Volume Mesh
• Conjugate Heat Transfer for Cooling Fins
  • Geometry and Mesh
  • Case
  • Results
• TU Berlin TurboLab Stator simulation using periodic boundary conditions
  • Description
  • Meshing the geometry
  • Defining the boundary conditions.
  • Case running
  • Translational periodic boundary conditions
• User Defined Dynamics
  • PI Controller for Angle of Attack to Control Lift Coefficient
  • Dynamic Grid Rotation using Structural Aerodynamic Load
• User Defined Postprocessing via userDefinedFields
  • Custom Output Variable
  • Custom surface integral